1.5. Temperature selection
By pressing
or
the one set, the radiator comes on, the
1.6. Manual / Automatic functions
By pressing
we change between the Manual and Automatic functions.
When the Manual function is selected, the symbol
Automatic function is selected, the symbol
1.6.1. Manual function
This enables to choose between the modes of operation COMFORT, ECO and ANTI-FROST,
changing the temperature as indicated in Section 1.5.
1.6.2. Automatic function
This mode activates the programming set on the radiator.
1.7. Programming
By repeatedly pressing
day. Pressing only once shows day one, twice shows day two and so on.
Pressing
for 3 seconds allows you to program the radiator directly:
1. Select the CONFORT temperature setting (20ºC to 30ºC), using
and the temperature will flash.
2. Press
and we can select using
The symbol
and the temperature will flash.
3. After pressing the button
show as SEL1, SEL2, SEL3.... We can go forwards and backwards using the button
. Press
to select the day that we wish to program.
4. Pressing
, takes us to the hour we wish to program. To change the hours use the
, buttons. The hours selected will show as (00H, 01H, 02H,...). By pressing the
we can select hour by hour the mode required: CONFORT, ECO or OFF.
5. To finish the programming press
6
we change the temperature. When the room temperature is lower than
ICON
MODE
COMFORT
ECO
ANTI-FROST
we can see the programming that is saved in the radiator for each
once again, the numbers of the week will start flashing and
or leave it for 30 seconds without pressing any buttons.
symbol appearing.
appears on the display. When the
appears on the display.
TEMPERATURE RANGE
20ºC – 30ºC
15ºC – 19,5ºC
8ºC
and
the ECO temperature (15ºC to 19.5ºC).
and
. The symbol
and
or
button,