Transport And Installation; Transport; Installation - WDT UP 35 Betriebsanleitung

5

Transport and Installation

5.1

Transport

The weight of the pneumatic Parallel Crimp Machine UP 35 is approx. 20 kg (44 lbs).
Screw in the t-handle (in the scope of the delivery) on the machine.
CAUTION
+
Use the T handle for the transport by hand!
ATTENTION
+
Tubes must not be damaged.
+
Wear suitable safety shoes when transporting and installing the machine.
INFORMATION
+
The pneumatic Parallel Crimp Machine UP 35 has to be carried with the T handle for the
transport by hand.
5.2

Installation

ATTENTION
+
Position the pneumatic Parallel Crimp Machine UP 35 on a flat surface and assure the
stability of the machine. Ensure that the table or bench is stable enough to support the
machine in normal use.
+
Assure an appropriate table height. The table height is dependent on the position of the
operator, (work in sitting or standing position) according to prEN 894-4:2004, Table A.1.
Assure appropriate illumination of the working place. (EN 1837:1999 – chapter 4.2: "The
+
general value of illumination has to be 500 lx [...]").
INFORMATION
+
To reduce production noise or vibration, the machine can be placed on an insulating
rubber mat.
Place the foot pedal on the floor. No other place is allowed!
ATTENTION
+
Place the tubes on the floor or out of the way so that they do not cause a trip hazard.
+
Do not lay the foot pedal in aisles or walkways.
+
Assure free access to the operating elements of the machine, especially the foot pedal
and the release button.
+
Wear suitable safety shoes when transporting and installing the machine.
INFORMATION
+
To ensure fatigue-proof use, the user has to take a working position, where the machine
is at the right height and the foot pedal is accessible. The foot pedal has to be installed in
a stable position. The position of the foot pedal should be chosen in that way, that a free
access will be possible.
UP35-4481N26000-02/15 – REV.B1
Page 44 / 63