Getting Started - Bellman BE1341 Bedienungsanleitung


Bellman Alarm Clock BE1341
Thank you for choosing products from Bellman & Symfon.
Bellman & Symfon AB have both separate products and also complete systems geared to helping
people with impaired hearing. An example of this is the Bellman Visit 868 System, which consists
of a number of radio transmitters and receivers. The transmitters detect different events in the
surrounding area and transmit a radio signal to the receivers. The receivers pick up this signal
and provide indications using light, sound and/or vibration.
Read through the entire user manual first and then start to use the products.

Getting started

Unpacking, installing and testing the unit
1. Connect the power supply unit to the socket (12). The Bellman Alarm Clock must be
connected to mains power for at least 24 hours in order to operate correctly. Set the
correct time with the Time Setting Knob (11).
2. Switch on the alarm with the Alarm Dial (5) by turning it to position 1. Turn the alarm
pointer anticlockwise using the Alarm Call Knob (10) until the alarm on the clock is
activated. The Bellman Alarm Clock will then emit sound and light signals and, if a
BE1270 Bellman Bed-shaker (accessory) is connected, it will vibrate. Press the Snooze
Button (4). The background light on the clock face will come on at the same time as the
alarm is switched off. The snooze function delays the alarm call for approximately 3.5
minutes. The Alarm Dial (5) is switched to position 0 to switch off the alarm completely.
3. Place the Bellman Alarm Clock upright on a level surface. The Alarm Clock is usually
placed near the bed but it can also be placed somewhere else where it can easily be seen
and heard. You can also easily take your Alarm Clock with you wherever you go.
Function
General
The BE 1341 Bellman Alarm Clock is an Alarm Clock for indoor use, which attracts the
attention of the user using sound and light signals and also vibration if a BE1270 Bellman Bed-
shaker (accessory) is connected.
It is activated by the clock's alarm, by connection to an external trigger input (13) or via direct
connection to a telephone socket (15).
Clock
The Bellman Alarm Clock will indicate an alarm call via sound, flash and vibration for up
to 15 minutes unless the alarm is turned off or onto snooze. The sound ranges across several
frequencies and increases in volume to attract attention better.