Adjusting The Carburettor; Storage; General Storage Instructions; Storage During Longer Breaks From Operation - Grizzly BRM 46-150 BSA InStart Originalbetriebsanleitung

• Check the blade for wear and dam-
age.
• Always have a blunt blade resharp-
ened by a specialist workshop, as an
imbalance check can be carried out
there.
• Always have a specialist workshop
change a damaged or imbalanced
blade. Incorrect installation can result
in serious injury.
1. Erect the device (see "Sto-
rage"). Make sure the lawn
mower is secure!
2. Use firm gloves and keep hold
of the blade (43). Use a span-
ner (width across flats 17) to
turn the blade bolt (44) counter-
clockwise from the motor spind-
le.
3. Reassemble the new blade in
the reverse order. Make sure
that the blade is positioned cor-
rectly and that the bolt is tighte-
ned.
Once you have loosened the blade
bolt (44), the conical spring washer
(45) must be replaced.

Adjusting the Carburettor

The carburettor has been preset in the
factory for optimum performance. If read-
justments are required, have the adjust-
ments made by a specialist workshop.

Storage

General Storage Instructions

Do not store the equipment
with a full collection box. In hot
weather, the grass begins to fer-
ment when heat is generated.
Risk of fire.
• Clean and service the equipment be-
fore storage.
• Allow the engine to cool before storing
the equipment in enclosed areas.
• Use suitable and authorised contain-
ers for storing fuel.
• Keep the equipment in a dry place
that is protected from dust and out of
reach of children.
• For space-saving storage, the upper
handle bar can be folded down (see
small image ) Release the quick-
release lever and fold down the handle
bar so the equipment takes up less
space. The Bowden cables must not
be squashed when doing this.
• Do not wrap the equipment in nylon
bags as damp and mould could form
Storage During Longer Breaks
from Operation
Non-observance of the storage
instructions may cause starting
problems or permanent damage
as a result of fuel residues in the
carburettor.
• Empty petrol tank in a well-ventilated
place.
• Empty carburettor: For this purpose,
start motor and leave it running until
the motor stops. Let motor cool down.
GB
115