E-Mu 1212M Bedienungsanleitung Seite 9

The AudioDock
The AudioDock connects to the E-MU 1010 PCI card via the EDI cable. The front of the AudioDock provides 2 balanced
mic/line preamp inputs, 1 set of MIDI I/O ports, a stereo optical S/PDIF output and a stereo headphone output.
Front Panel Connections
Insert 1/4"
Signal/Clip
Plug for Line Level
Indicators
-10dB to +25dB Gain
A Line B Line
Mic
Clip
-12 dB
Line - -10 dB
Mic - +20 dB
Insert XLR Plug
for Mic Level
+20dB to +55dB Gain
The front panel mono Mic/Line inputs A & B can be used as balanced microphone inputs, hi-Z guitar pickup
inputs, or balanced line level inputs. The Neutrik combination jack accepts microphones using a standard XLR
Preamp Section connector or line level/hi-Z inputs using a 1/4 inch TRS phone plug.
Warning: Some microphones cannot tolerate phantom power and may be damaged. Check the microphone' s
specifications and requirements before using phantom power.
MIDI input and output ports allow you to interface any type of MIDI equipment such as keyboards, effect units,
MIDI 1 In/Out drum or guitar controllers. The MIDI drivers were installed when you installed your Patchmix DSP software and
the MIDI ports will appear in your system control panel under "Sounds and Audio Devices".
Phantom
Power On/Off
Mic
48V
Clip
-12 dB
-10 dB
+20 dB
Input Gain
Controls
S/PDIF
Optical Out
MIDI
1 LCK
2 2 EXT
MIDI 1
S/PDIF
Out
In Out
MIDI #1 Headphone
I/O Jacks Output
LED
Indicators
CLOCK SMPTE
44.1 96 IN
48 192 OUT
Headphone
Volume
Getting Started - 9