Hardware Installation - E-Mu 1212M Bedienungsanleitung

2 - Hardware Installation

Step 1: Prepare your computer
Metal brackets
1. Turn off your computer and all peripheral devices.
2. Touch a metal plate on your computer to ground yourself and to discharge any static
3. Remove the computer cover.
4. Remove the metal brackets from two adjacent PCI slots. If you have the E-MU 1820 system
PCI slots
ISA slots
Step 2: Install the E-MU 1010 PCI card
1. Align the E-MU 1010 PCI card with the slot and press gently but firmly down into the slot
2. Do not force the E-MU 1010 card into the slot. Make sure that the gold finger connector of
3. Secure the card to the slot using a screw (if necessary).
electricity, and then unplug the power cord from the wall outlet.
you only need to remove the bracket from a single PCI slot. See the figure at left.
as shown in the figure opposite.
the card is aligned with the PCI bus connector on the motherboard before you insert the
card into the PCI slot. If it doesn't fit properly, gently remove it and try again.
Getting Started - 3