Siemens slider SL22 Gebrauchsanleitung Seite 15

• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an earthed
socket. If it is absolutely necessary to use an
extension cable, make sure that it is suitable for
16A and has a socket with an earth connection.
• If the safety fuse fitted in the appliance blows, the
appliance will be rendered inoperative. To restore
normal operation the appliance will have to be
taken to an authorised Technical Service Centre.
• In order to avoid that, under unfavourable mains
conditions, phenomena like transient voltage
drops or lighting fluctuations can happen, it is
recommended that the iron is connected to a
power supply system with a maximum
impedance of 0.35Ω . If necessary, the user
can ask the public power supply company for
the system impedance at the interface point.
• The appliance must never be placed directly
under the tap to fill the water tank.
• Unplug the appliance from the mains supply after
each use, or if a fault is suspected.
• The electrical plug must not be removed from the
socket by pulling the cable.
• Never immerse the iron in water or any other fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.)
Important:
▪
This appliance reaches high temperatures and
produces steam during use, this could cause scalds
or burns if not used properly.
▪
The steam hose, base station, metal plate at the
bottom of the removable iron pad (2) and in
particular the iron can get hot when used. This is
normal.
▪
Never aim the steam at people or animals.
▪
Do not allow the power cable to come into contact
with the soleplate when it is hot.
▪
Be aware that the system can keep on steaming
for a short additional time after releasing the
steam trigger. This is a normal function.
Description
1. Water tank
2. Removable iron pad
3. Steam hose storage fixing
4. "calc'nClean Plus" scale collector
5. Mains cable storage compartment
6. Mains cable
7. Steam hose
8. "Energy Saving" button *
9. "Steam ready" / "Auto shut-off*" pilot light
10. "on / off" pilot light *
11. Variable steam control *
12. "Refill water tank" / "Clean warning" pilot
light*
13. Main power switch (0/I)
14. Iron fixation system "secureLock"
15. Housing with internal steam generator
16. Temperature control knob
17. Steam release button
18. Steam shot button "XTRM" *
19. Iron pilot light
20. Soleplate
21. Fabric-protection soleplate cover *
* model dependent
a
preparations
1. Release the iron from its lock system (14) by
pulling the lever located at the heel of the iron
backwards.
2. Remove any label or protective covering from
the soleplate.
3. Place the appliance horizontally on a solid,
stable surface. You may remove the iron pad
from the appliance and place the iron on it on
another solid, stable, horizontal surface.
4. Fill the water tank, making sure not to pass the
level mark.
5. Unwind the mains cable (6) fully and plug it
into an earthed socket.
6. Set the main power switch (13) to the on
position.
7. The "Steam ready" indicator lamp (9) will light
up after several minutes, indicating that the
appliance is ready to use.
The steam generator will take more time to
reach "Steam ready" state only upon the initial
heating up, or after performing the de-scaling
operation (Calc'n'Clean).
When water is already present in the steam
generator during regular use, heat up time to
reach the operating temperature will be faster.
15
SIEM ENS