Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage and before all other connec-
tions have been made.
• Do not cover any vents and make sure that there is a space of several centimeters around the unit
for ventilation.
Connections
• Connect the power cord (29) to ac outlet and connect the speaker jack to the speaker socket (27)
located on the rear side of unit.
• Press the power button (6) and if power led indicator (5) light up, it's mean the power supply is nor-
mal. Now your system is ready to play the music.
Setting the clock
1
Set unit in standby mode.
2
Press & hold the "mem/clk-adj" button (17), the lCD display (5) will show " set clock " and then
display " 12hr or 24 hr " press skip
format(12hr/24hr). Press "mem/clk-adj" button (17) again to confirm.
3
The lCD (21) will display the first & second digit of "00" is flashing. Press skip
(2) to set the correct hour. Press "mem/clk-adj" button (17) to store the correct hour.
4
The third & fourth digit of "00" is flashing, press the skip
minutes. Then press "mem/clk-adj" (17) to store the correct minute.
Note: the pre-set time will be re-set completely if dis-connecting the main power supply. You are recom-
mended to switch the system into standby mode for convenience usage.
Manual tuning
1
Press function button (19) to select " tuner " mode.
2
Press "band/
" button (15) to select desired band (MW or FM).
3
Tune to the required station by pressing the " tuning / skip up or down (2) button.
4
Adjust volume control (20) to the desired volume level.
Installation and Operation
or skip
Radio Functions
button (2) to select the appropiate area hour
or skip
button (2) to set the correct
or skip
button
19
www.auna.de
Werbung
Inhaltsverzeichnis
