Charging The Battery; Cleaning And Maintenance - Blaupunkt DTS801 Bedienungsanleitung

DTS801
1. Replaceable toothbrush head
2. On/Off switch
3. Power monitor diodes
4. Handle with drive
5. Charging unit
6. Operating-mode toggle button
7. UV Lamp

CHARGING THE BATTERY

Make sure that the toothbrush is switched off before placing it on the charging unit.
Connect the charging unit (5) to the power supply. Place the toothbrush handle with drive on the
charging unit. The full charging process can last more than 24 hours. It is recommended to store the
toothbrush handle in the charging unit. The battery contains a protecting circuit against overcharging.
When the battery is charging the toothbrush, the battery-charging indicator will turn red. When the
battery is fully charged, the indicator will turn green.
USING YOUR TOOTHBRUSH
1. Use the replaceable toothbrush head (1) on the handle with a drive (4). Wet the toothbrush with
water and apply a small amount of toothpaste.
2. Put the toothbrush in your mouth, on the teeth gently tilted toward the gums (as shown in the
Figure)
3. Turn on your toothbrush with the switch button (2). You can change the brushing mode by
pressing the switch button immediately after switching on the toothbrush – the operating mode
changes.
4. To improve the efficiency of teeth cleaning, the mouth should be divided into four zones. Clean
each zone for 30 seconds (the toothbrush signals with a momentary break when each 30 seconds
expires). The toothbrush will switch off automatically after 2 minutes. To finish teeth cleaning
earlier, turn off the toothbrush with the switch button
5. After switching the toothbrush off, remove the head (1) from the handle (4) and thoroughly rinse
both elements.
6. Put the handle (4) onto the charging unit (5).
BRUSHING MODES
1. CLEAN - standard brushing mode
2. SOFT - gentle brushing mode
3. MASSAGE - pulse mode to stimulate the gums
4. WHITEN - brushing, whitening and polishing
DISINFECTING THE TOOTHBRUSH HEADS
Make sure that remaining water has been removed from the toothbrush head.
Open the cover of the disinfecting compartment and put in the head, directing the bristles towards the
UV lamp. Close the cover. The UV lamp will switch on automatically for 10 min after closing the cover.
The disinfection process will start with each closing of the disinfection-compartment cover.
WARNING: UV light is dangerous for the eyes and skin. Do not open the disinfection-compartment
cover during the disinfection process. If it is observed that the UV lamp lights although the
disinfection-compartment cover is opened, contact the service centre.

CLEANING AND MAINTENANCE

Make sure that the charging unit is removed from the power supply before starting cleaning.
8. Disinfection-compartment cover
9. Portable charging station
9a. USB charging socket
9b. Port for handle with motor
9c. Replaceable toothbrush heads
9d. UV Lamp
10. USB charging cable
3