Lehmannaudio Decade Bedienungsanleitung Seite 21

40 Decade
6 + 10 | Input jacks (IN)
EN
Connect the cables coming from your record player to these jacks. The left jack
(black) is for the left channel, the right jack (red) for the right channel. Please be
sure to connect the channels correctly.
7 + 9 | Output jacks (OUT)
RIAA filtered high-level output. Connect the cables that either lead to the input of
a downstream high-level pre-amplifier (high-level inputs are labelled 'Line', 'AUX',
'CD', 'Tuner' etc.) or directly to a power amplifier with volume control. Here too,
please be sure to connect the cables to the correct channels.
ATTENTION!
Never connect the output of the Decade to the phono input of
another device. This could damage the phono stage or speakers.
8 | Input for the PXW II power supply
First connect the 4-pole Neutrik XLR plug to the audio device. Only then
connect the power supply to the mains outlet. Please do never plug in or pull off
this connection during operation.
PWX II power supply front panel
11
11 | Operating mode display (LED)
When the LED is lit up, the PWX II power supply is operational.
12 + 13 | Power supply output
The wattage of a PWX II power supply will be sufficient for one Decade plus
another phono device of the Black Cube series (Black Cube/Black Cube SE II).
Both power supply outlets are equivalent.
14 | Mains switch
With the mains switch on the PWX II power supply the Decade can be turned
on or off.
Decade 41
EN