Installation - Lehmannaudio Decade Bedienungsanleitung

36 Decade

Installation

EN
This section tells you about the connections, control elements
and application possibilities of your Lehmannaudio Decade
phono amplifier.
1 | Unpacking
After unpacking the Decade check it for possible transport damages. If you
notice visible damages, you must by no means connect the device to mains. In
this case consult your dealer immediately.
Delivery includes the following components:
Decade device
≠
PWX II power supply
≠
XLR connection cable between
≠
power supply and audio device
Note
We recommend keeping the entire packaging for later shipment.
That way you will avoid transport damages. Use by no means
'foam chips' or similar packaging material. Otherwise the device
will jolt through to the bottom of the cardboard box during
transport and can be damaged! If the original packaging is no
longer available, it's best to use bubble wrap in which to wrap up
the device in a generous manner. Finally the whole should be put
into a solid cardboard box.
User manual
≠
Allen key (2 mm)
≠
Certificate of warranty
≠
2 | Setup
Always position the Decade on a stable surface. Thanks to the compact dimen-
sions and low weight, you can set up the Decade directly next to the record
player.
3 | Connecting
Check whether the included mains adapter is suitable for connection to the
mains network used in your country. On the adapter, you will find information
about the specified mains voltage for the device. Now connect the Decade to
the mains network using the external power supply and the connection on the
rear of the device.
Note the safety instructions starting on page 32!
Decade 37
EN