SOLIS Vapo-Flute 711 Bedienungsanleitung Seite 44

• Close the water reservoir by screwing the water
reservoir cap with de-calcification cartridge in
clockwise (Ill. 5). The ring seal in the cap should
be correctly positioned.
• Now turn the water reservoir back upright and
place it back onto the base. The two arrows on the
tank and on the base must be aligned, otherwise
the two parts will not fit together (Ill. 6a + b). If
you now hear a gurgling noise it means that water
is flowing into the atomizer chamber. If you do not
hear this noise, lift up the water reservoir again
and slowly lower it onto the base until you hear
the gurgling noise.
• Place the desired outlet nozzle onto the appliance
(Ill. 7). Make sure that the ridge on the nozzle slots
into the indent in the water reservoir.
• Place the ultrasonic-atomizer on a level, stable and
moisture resistant surface. Caution: Do not place
the appliance on a moisture sensitive surface
especially when using the short outlet nozzle
since the damp mist quickly sinks down to the
surface and moisture gathers there.
Do not place the appliance on deep-pile car-
•
pets, as these can block air openings on the
bottom.
2 . sW i tc h i n g a p pl ia n ce o n
an d s e tt in g
• Check, once again, that the surface under the
appliance is moisture resistant and is not deep-
pile. If there are water droplets on the appliance,
power cable or plug, please wipe them off. Once
you have placed the water reservoir onto the base,
wait 3 to 5 minutes before plugging it into a mains
socket. You will hear a "Ding-Dong", your appli-
ance is in stand-by mode.
44
Ill. 5
Ill. 6a
Ill. 6b
Ill. 7