Putting Into Operation - Lehmannaudio Black Cube SE II Bedienungsanleitung

40 Black Cube SE II
EN
ATTENTION!
Never connect the output of the Black Cube SE II to the phono
input of another device. This could damage the phono stage or
speakers.
5 + 7 | Input jacks (IN)
Connect the cables coming from your record player to these jacks. Here too,
please be sure to connect the cables to the correct channels.

Putting into operation

To put your Black Cube SE II into operation, you need informati-
on about your pick-up system.
Two details are important: Are we talking about an MM (moving magnet) or MC
(moving coil) system? What is the required connection resistance? As a rule, you will
find both pieces of information on the product packaging of your pick-up system.
Please ask your specialist dealer for recommended values in case of doubt. Support for
correctly configuring your Black Cube SE II will be gladly provided.
Once you have the required information, please proceed as follows:
1 | Set the volume on your system to minimum or turn your amplifier off entirely.
2 | Connect the power supply.
3 | Set the gain for your pick-up system (MM/MC) on the Black Cube SE II.
The settings must be made in the same way for both channels and are done
by means of the DIP switches A and B on the bottom side of the device.
Common amplifier settings for various types of pick-ups are found on the next
page. The gain switch (respectively B1) is active on delivery.
4 | Set the terminating resistance on the Black Cube SE II. The setting must be
identical for both channels. Use the custom impedances inside and the DIP
switches on the bottom of the device. Further information is found on page
44.
5 | Connect the record player to the input on the Black Cube SE II.
6 | Connect the output on the Black Cube SE II to a line input on the
downstream amplifier. To largely exclude line losses, the signal cables should
be kept short.
Black Cube SE II 41
EN