Installation - Lehmannaudio Black Cube SE II Bedienungsanleitung

36 Black Cube SE II

Installation

EN
This section tells you about the connections, control elements
and application possibilities of your Lehmannaudio Black Cube
SE II phono amplifier.
1 | Unpacking
After unpacking the Black Cube SE II check it for possible transport damages. If
you notice visible damages, you must by no means connect the device to mains.
In this case consult your dealer immediately.
Delivery includes the following components:
Black Cube SE II device
≠
PWX power supply
≠
Mains cable
≠
User manual
≠
Note
We recommend keeping the entire packaging for later shipment.
That way you will avoid transport damages. Use by no means
'foam chips' or similar packaging material. Otherwise the device
will jolt through to the bottom of the cardboard box during
transport and can be damaged! If the original packaging is no
longer available, it's best to use bubble wrap in which to wrap up
the device in a generous manner. Finally the whole should be put
into a solid cardboard box.
Allen key (2 mm)
≠
2 jumpers
≠
Certificate of warranty
≠
2 | Setup
Always position the Black Cube SE II on a stable surface. Thanks to the compact
dimensions and low weight, you can set up the Black Cube SE II directly next to
the record player.
3 | Connecting
Check whether the included mains adapter is suitable for connection to the
mains network used in your country. On the adapter, you will find information
about the specified mains voltage for the device. Now connect the Black Cube
SE II to the mains network using the external power supply and the connection
on the rear of the device.
Note the safety instructions starting on page 32!
Black Cube SE II 37
EN