Preparation; Usage - T4W 59352 Bedienungsanleitung

Please read the operating instructions carefully before using the device, and
keep them in a safe place. If the device is passed on to a third party, it is
Imperative that these instructions also be passed on with it.

Preparation

• Check before use that all parts are undamaged and working correctly.
• Unscrew the pump from the tank.
• Fill the canister with liquid up to the "max" level.
• Screw the pump head on and tighten it so that the canister is sealed and airtight (if it
is not, it will be impossible for pressure to build up).

Usage

• Pump air into the tank using the piston (around 20 to 30 pump movements).
• Important It is not possible to generate more pressure in the tank than specified. The
sprayers are fitted with an automatic relief valve.
• Press the spray button to spray. By turning the spray nut, you can set the desired
spray pattern (mist - jet).
• On models with a safety function, the safety button must be pulled back before the
spray button can be pressed.
• In the case of models with a continuous spray function, the spray lever will lock into
place once pressed.
• Pushing back the lock button will cause the spray lever to Jump back to the original
position.
• If liquid continues to drip out of the nozzle when releasing the spray button, there is
still air in the sprayer. Spray upwards at an incllne for around two to three seconds to
enable the air to escape.
• The ability to spray evenly and without any problems is dependent on the use of a
clean spray agent
• Mix chemicals and water thoroughly prior to fining.
• Please note the usage Instructions of the chemical manufacturer.
4