Pioneer PDP-S40 Bedienungsanleitung Seite 3

Plasma Display with the speaker installed
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(right side)
INSTALLATION ON THE PLASMA
DISPLAY
Perform installation according to the following steps 1 to 4.
NOTE:
Before attaching the speaker, please attach the PDK-
TS25 table top stand (or another Pioneer Plasma Display
stand) to the Plasma Display unit.
1. Attach the speaker mounting fittings to the
rear of the Plasma Display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the Plasma Display using
the supplied screws.
Speaker mounting
screw (M5 x 10
mm)
"L" is inscribed
("R" is inscribed
on the fitting for
the right side).
Speaker mounting fitting for the
left side
(the fitting method is the same
as the fitting for the right side)
Speaker mounting
screw (M5 x 10 mm)
Speaker cable
Bead Band
(Accessories of the
Plasma Display)
1.Tighten the screw
in the upper screw
hole first.
2.Then, tighten the screw
in the screw hole right
under the upper hole.
Speaker
Speaker mounting
fitting (center)
2. Attach the center fitting to the lower center
on the rear panel of the Plasma Display.
• Attach the center fitting to the lower center on the rear
panel of the Plasma Display using the two supplied
screws.
2.Then tighten the
screw in the oval-
shaped screw
hole.
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting for
center
Note
• See page 6 for speaker mounting procedures when using
the hung on wall unit.
English
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
fitting (left side)
1. Tighten the screw in
the round-shaped hole
first.
3