Inhaltsverzeichnis
Werbung
5
16
1
2
3
4
CONVERSION TO A DIFFERENT TYPE OF
GAS
Before converting the appliance for operation with
a different gas type, check which type of gas it is
currently set to operate with (adhesive label 1 on
appliance).
For the correct nozzle diameter, refer to the table
"Nozzle Table".
Attention! Connection to the gas supply
and converting to a different type of gas
must be carried out by qualified technicians
and in conformance with the requirements.
Depending
on
regulations, may be used different (from
mentioned) types of connections.
Conversion procedure:
•
Disconnect the electrical power supply to
the appliance,
•
Change the main oven nozzle:
•
Remove the burner cover plate (see
«Removal of the burner cover plate»),
•
Remove the screws securing the oven
burner 2 and with draw the burner from the
support together with the heat sensor and
the ignition spark plug,
•
Remove the nozzle using a 7 mm box
wrench 3,
•
Screw the new nozzle in fully (diameter in
hundredths of millimetre stamped on the
nozzle), taking care not to cross the thread,
Loosen the screw 4 and adjust according
•
to table the opening size a for air supply by
rotation of the sleeve 5,
Tighten the screw 4,
•
•
Replace
the
operations in step 2 above,
•
Replace the cover plate.
NOZZLE TABLE
Rated
Burner
load kW
G20/20
Oven
2,50
1,18
burner
TABLE OPENING SIZE
Type of gas
Natural gas
a
Size
, mm
EN
regional
rules
and
burner
reversing
Nozzle bore in mm
G30/50
G30/29
0,77
0,65
Liquid gas
4,0
10,0
the
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
