Installing The Seat In The Car - be cool ZERO Gebrauchsanweisung

EN
3

3. INSTALLING THE SEAT IN THE CAR

The ZERO safety seat must be installed FACING THE OPPOSITE DIRECTION IN WHICH THE
CAR IS TRAVELLING. Decide on the seat after reading the "Choosing where to install the
safety seat" section.
To install the seat carefully follow the steps below:
3a.- Position the safety seat on the vehicle seat.
3b.- Pass the seat belt buckle over the baby's feet and fasten it.
3c.- Insert the abdominal part of the seat belt through the slots (1) on the sides of the frame.
3d.- The shoulder part of the vehicle seat belt should be passed behind the safety seat.
3e.- Turn the handle (6) to the AUTO position, the furthest forward. The full car symbol should
be displayed on the sides of the handle.
3f.- Tighten the car seat belt and fasten the locking clip (2). Make sure that the safety seat is
securely anchored by pulling it.
WARNING: For installing rear facing safety seats, the correct guides for fitting the seat belt
are marked on the chassis in blue. DO NOT use any guide that is not described in these
instructions or any on the baby carrier that are not coloured blue.
If the safety seat is installed with the ISOfix base (optional), follow the instructions on the
base.
4. PUTTING THE BABY INTO THE SAFETY SEAT
4
4a.- Loosen the harness by puling on the shoulder straps while pressing the tightener button
(8).
4b.-Undo the clasp.
4c.- Put the baby in the safety seat, making sure that they are sitting back in it and that their
back is straight. Join the top ends of the clasps.
4d.-Insert them in the fastener and press until you hear a ZERO.
4e.-Tighten the shoulder straps and pull the tightener strap (7).
5 5. INSTALLING ZERO IN A PUSHCHAIR
Your ZERO carrycot can be fastened to any BE COOL chassis that has the PRO-FIX system.
5a.- To fasten the safety seat to a chassis, insert the connections in the cavities on the chassis
and press until you hear a ZERO.
5b.- To release the ZERO from the chassis, pull both buttons on the sides of the handle (9)
and lift the seat
WARNING
Never leave your baby on their own.
Any changes or additions to the ZERO without the correct authorisation from BE COOL may
seriously affect the safety of the restraining system.
Read these instructions carefully before use and keep them for future reference. Your child's
safety may be affected if you do not follow these instructions.
This safety device cannot be used without its cover, or replaced with one that is not the origi-
nal, as it is an integral part of the system's safety features.
16