Fava PT6 Kit Bedienungsanleitung Seite 23

Batteries replacement is recommended every three years (or if it is
empty). Proceed as follows:
•
Switch off the device (switch OFF or release the black button)
•
Remove screw (Fig. 1 or Fig. 2/d) of set holding back cover.
•
Remove back cover
•
Remove and replace batteries being careful to match the cor-
rect polarity
•
Replace back cover and screw. Do not overtighten screws.
5. Technical Specifications
PT6 Probe - Physical
Dimensions
Weight
Electrical
LED
Reduced Bandwith
S i g n a l
Power supply
Battery life
Temperature:
TG6 Tone Generator - Physical
Dimensions
Weight
Electrical
Output Power
Frequency
Short circuit indication: less than 75 ohms
Line voltage protection:120 V∿ oder 110V����
Power supply
Battery life
Temperature:
Standards
Quality
EMC
49x245mm
ca. 230 g.
High efficiency white LED
1050Hz
f i l t e r e d : 300-3400Hz (not f..: 200-5000Hz)
4 Batteries Typ AA (LR6)
ca. 250 hours
0-50°C (Operating)
118x62x30 mm
ca. 210 g.
+6dBm @ 600Ω
alternating 900/1050 Hz at a 2 Hz rate
4 Batteries Typ AA (LR6)
ca. 250 hours
0-50°C (Operating)
according to EN ISO 9001:2008
according to EN 61326-1:2013
- 23 -