Fava PT6 Kit Bedienungsanleitung Seite 20

2. Description
PT6 Kit is designed basically to quickly identify or trace telephone, electrical
or alarm wiring. The probe is able to detect the powerful signal generated by
the toner - even at a considerable distance – at the cable termination for ex-
ample in telephone distribution cabinets or in pits. By generating an acoustic
signal (quiet in low and loud the signal is strong) and simultaneous illumina-
tion of the green LED (Fig. 1/c) PT6 probe identifies the correct wire. The
TG6 tone generator can only be used on non-busy lines.
3. Operation
Connection to AC (230V
age the instrument and could result in severe injury and
death of the user.
Use caution around voltages above 30 V
V
Product warranty is voided immediately.
3.1. On/Off
PT6 Probe
To activate PT6 Advanced Tone Probe, push and hold the black on/off
button (Fig. 1/a): the bright white LED headlight (Fig. 1/e) for probing in
dim locations is always on. Releasing the black button (Fig. 1/a)will turn
the unit off.
TG6 Tone Generator
To turn on TG6 Tone Generator, move the switch (Fig. 2/b) from OFF
in one of the two positions: SHORT or LINE.
To turn it off, move the switch to OFF.
3.2. Check short circuit
TG6 can check the test connection for a short circuit. Proceed as fol-
lows:
•
Connect the test leads to the inactive wires.
•
Switch the tone generator to the SHORT (Fig. 2/b) Position.
•
If a short is detected the LINE LED shows steady green and a
warning tone can be heard.
����
. These voltages pose a shock hazard.
∿
) power line voltages will dam-
- 20 -
∿
rms, or 60