Operation - auna multimedia 10028976 Anschluss- Und Anwendungshinweise

Setup
• Carefully take the tower body and base out of the packaging.
• Take the screws and washers out
• Attach the base to the body aligning the two holes in the base with the two holes in the tower
• Screw the base into the body
• Stand the tower upright on the floor. The appliance is now ready for use
General operation
• Press to turn on or tum off the unit.
• Press the SOURCE button repeatedly to select the playback source. The LED indicator will light blue
according to BT mode
• Press the VOL(Volume)+/- Buttons to adjust volume level.
• Press the Button control to choose the tracks.
• lf the unit is not used for a long period of time, pull out the plug to turn off the unit completely.
Line In
• Connect your auxiliary device (e.g. smart phone/ MP3 player) to the 3.5mm LINE jack
• Press button to turn on the unit. Press the SOURCE button repeatedly unit the LINE indicator turn
green.
• Press Play/Pause on your auxiliary source.
• Adjust the volume to desired level.
• To stop playback, disconnect your auxiliary source from the LINE jack.
USB
You can connect a USB flash device (not included) to the USB port t on the unit to play MP3 files.
• Press SOURCE into the USB mode. the USB indicator will turns green.
• USB device can auto play
• Press PREVIOUS/NEXT to select track.
Note:
• Supported format: MP3 (32kbps-320kbps)
• The total number of MP3 files on the Memory Device should not exceed 999.
• If you can't easily insert the memory card, you may have inserted it incorrectly. Try to turn over
the card and then insert again.
• For playing files on USB flash drive, you should plug in the USB flash drive when the unit is in
standby mode. Turn ON the unit and use MODE button to select USB mode.
10

Operation