Fm Radio - oneConcept 10032325 Bedienungsanleitung

where 'X' is the number of the preset (1-10).
Tune to a DAB station preset
1 Press and release the Preset button. 'Preset Recall' is displayed together
with the number of the current preset location.
2 Turning the select knob to select the Preset location and station that you
would like to listen to (1-10).
3 Press and release the Select knob. The Speaker will tune to that station
and begin to play.

FM RADIO

1. Press Source button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range
(87.50 MHz).
Otherwise, the last listened FM station will be selected.
3. Press button to scan down the frequency band. Your Radio will search
for the next available station and then stop on that station.
4. Press the > or < button to fine tune each frequency in 0.05 MHz steps, if
necessary.
Changing the scan setting
1. Press and hold the Menu/Info button to enter the menu options. '<Scan
setting>' will be displayed. Press and release the Select button. There are
now two different options to choose.
a. Strong stations The scan will only stop when a strong signal strength is
received which should also result in a better audio quality. It is possible
that the station you are scanning for may be missed using this option.
a. All stations
The scan will stop for every station it receives, even if the signal strength
is poor.
2. Turning the Select Knob to your want options, Press and release the Select
button to confirm.
3. Press and release the Menu/Info button to exit from the Menu.
Storing an FM station preset
Your Speaker can store up to 10 FM radio stations in its preset memories for
instant access to your favourite stations.
1. Tune the Speaker to the FM radio station that you wish to preset.
2. Press and hold the Preset button for approximately 2 seconds until 'Save
to Preset' is displayed.
3. Turning the select knob to select the Preset location that you would like to
store the radio station to (1-10).
4. Press and release the Select knob. The display will confirm 'Preset X saved' ,
EN
21