Grass Collector; Mounting Of The Handle - Texas A/S XTB 46 TR/W Bedienungsanleitung

Grass collector

Assemble the grass catcher as shown.
Mount the black metal bracket inside the cover.
Attach the black collecting tray to the cover, as
shown.
Clip the white clip attached to the bag over the black
bracket.

Mounting of the handle

The lawn mower is supplied almost fully
assembled.
Remove the lawn mower from the box
and pull the top control in the direction
of the arrow.
1
Check that the cables do not become
trapped.
2
Once the control is unfolded, tighten the
four wing nuts (2).
Tighten the brackets (1) in the centre of
the control. Take care not to tighten the
innermost adjustment screw too much.
If this happens, it could damage the
bracket.
Cable
The clutch cabel (a) will from delivery be dismounted from the metal bracket (b).
To fit the cable, the metal bracket (b) must be pulled out of the hole in left side of
handlebar. See fig. 1.
Then fit the s-hook from cable into the hole in metal bracket. See fig. 2.
At last, the metal bracket must be pushed back into the hole in handle bar. Fig. 3.
Check that it works before start engine.
Fig. 1 Fig. 2 Fig. 3
a
b
19