Electrolux IK307BN Benutzerinformation Seite 14

14 www.electrolux.com
Problem
A square symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Fast‐
Freeze,FastCool or after
changing the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Possible cause
Temperature sensor prob‐
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
Solution
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
Close and open the door.
Contact the nearest Au‐
thorized Service Centre.
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "FastCool func‐
tion".
The compressor starts af‐
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.