Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
for
and
buttons
2 is sec – 40 sec.
Factory setting
Press „P" button for 5 se-
conds. All 3 buttons will
flash.
Cleaning
Old coffee grounds remai-
ning in the appliance can
lead to oxidation. That
spoils the beverage; it can
cause an unpleasant, ran-
cid taste. The appliance
should always be in opti-
mum condition to be able
to provide optimum re-
sults at any time.
Ensure the appliance is
switched
off
and
plugged from the power
socket.
Clean the exterior of the
x
appliance with a soft,
moist cloth. If heavily
soiled, a mild detergent
can be used.
10
Take off the coffee bean
x
container. Press it down
and turn counter-clock-
wise.
Take out the unused
x
beans and put them in an
airtight container so they
stay fresh.
Clean the coffee bean
x
container and the coffee
grounds container with
warm water and a little
bit of detergent.
After that, dry both con-
x
tainer well.
Cleaning the burrs
If the coffee grinder is used
frequently (every day), the
burrs need to be cleaned
un-
every three weeks to en-
sure best performance of
the coffee grinder. Regular
cleaning helps the burrs
achieve consistent grin-
ding results, which is espe-
cially important when grin-
ding coffee for espresso.
Remove the coffee bean
x
container as described in
"Cleaning".
Turn the grind adjustment
x
collar counter-clockwise
until the graphic arrow
on the grind adjustment
collar is aligned with the
first arrow on backside of
the appliance.
Press the unlock button
x
and turn the grind ad-
justment collar until the
upper graphic arrow is
aligned on the second
graphic arrow on the
backside of the appli-
ance.
Remove the grind adjust-
x
ment collar including the
top burr.
Lift out the top burr from
x
the grind adjustment col-
lar and clean it using the
burr cleaning brush.
Also clean the upper burr
x
with the cleaning brush.
After cleaning return the
x
grind adjustment collar
to its position on the ap-
pliance.
The upper graphic arrow
x
is aligned with the second
graphic arrow (Align).
Replace the top burr
x
back into position in the
grind adjustment collar
and turn clockwise to the
desired grind setting.
Notice:
To check if the burr was
inserted correctly, you can
try to pull out the burr on
the metal ring. Now, the
burr should not be remo-
vable.
Adjustment of top burr.
By adjusting the burr you
can adjust the grind set-
ting coarser or finer.
Remove the top burr as
x
described in "Cleaning
the burrs".
Remove the two small
x
Werbung
