Ronda 370 Betriebsanleitung Seite 34

Brugsanvisning / Betriebsanleitung / User Manual
Assembling and Collection of Liquids
When the machine has been correctly assembled and connected, it can be switched on at the switch of the motor
top. The suction motor of the machine is switched on at the one switch and the pump at the other. When the
suction motor or the pump is on, the light in the switch will be on. The switch of the pump is marked with a
"PUMP" label.
When the collection container is full, the float valve will cut off the air flow to the suction motor, and the collection
will stop.
Switch off the suction motor immediately so that the motor is not unnecessarily loaded.
Empty the collection container. (See the next paragraph)
Note: Clean the machine after use! See: Cleaning and maintenance.
Removal of Collection Container
Dismount the motor top of the machine by loosening the two container clips on the sides of the collection
container.
When putting in the new collection bag you must make sure that the lifting strip is hanging out of the machine. If
not, the bag may fall off, and sludge may damage the machine.
NB: Let the machine run for 5-10 minutes after having finished the collection, as this will make the water
come out of the collection bag.
RONDA 370
Now the motor top can be removed from
the trolley frame.
Loosen the collection bag from the
container coupling and lift the bag out of the
collection container.
In connection with the replacement of the
collection bag it should be checked that
there is no sludge or solid substances at
the bottom of the machine, as these may
clog up the intake filter to the pump.
34 V. BRØNDUM A/S