Koenic KVR 4120 Gebrauchsanweisung Seite 20

English
Note:
• Floor nozzles are subject to a certain
amount of wear, depending on the type
of hard floors you have (e.g. rough, rustic
tiles). Therefore, you must check the
underside of the floor nozzle at regular
intervals.
• Worn undersides of floor nozzles may
have sharp edges that can damage
sensitive hard floors, such as parquet
or linoleum. The Imtron GmbH does not
accept any responsibility for damage
caused by worn floor nozzles.
Troubleshooting
If there are any problems during operation, please refer to the following table. If problems cannot
be solved as indicated under Solution, please contact your manufacturer.
Problem
Product does not work
Product cannot absorb
dust or loose suction
power
Rolling brush does not
work
Floor nozzle difficult to
move or get jammed
20
IM_KVR4120_180806_V06_HR.indb 20
Technical data
Re-chargeable vacuum cleaner
Rated voltage
Vacuum power
Battery charging time : 3.5 hrs.
Dust container capacity : 0.3 L
Power adaptor
Model
Rated Input
Rated output
Protection class
Possible causes
• Interrupted power supply
• Battery is empty
• Filters are blocked with dirt
• Dust container full, exceed
MAX marking
• Tube blocked
• Brush is blocked with threads
and hairs
• Wheels are blocked with
threads and hair
: 21.6 V
: Max. 120 W
: MC2508A-V
: 100 - 240 V ~
50-60 Hz 0.8 A
: 25-29V 800 mA
: II
Solution
• Check the power supply
• Re-charge battery
• Clean and wash the filters
• Empty dust container
• Remove blockage from
tube
• Cut and remove the threads
and hairs from the brush
• Remove them carefully by
using a flat screwdriver
6/8/18 2:38 pm