Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
device, as it may affect battery life.
• Rechargeable lithium-ion battery
• Voltage: 24 V
• Capacity: 4,4 Ah
• Working temperature: -10ºC~+50ºC
• Charging temperature: 0ºC~+40ºC
• Relative storage humidity: 5~95%
The cruiser is ready to use after unpacking.
During use, especially when driving on uneven ground, the device may get decalibrated.
Decalibration of the device causes the cruiser unsuitable for further use, which is
signalized by flashing red indicator on the device. In such case, it is necessary to perform
a calibration. Calibration will tune the gyroscope and its sensors, which might have
gotten distorted as a result of shocks or impact during driving.
To calibrate the device:
1. Make sure the device is powered off.
2. Place the cruiser on flat and even ground. It's important to make sure that both
wheels are on the same level.
3. Once you have made sure that both wheels are positioned correctly and the device is
stably placed on even ground, press and hold the power button for about 5 seconds,
until the red indicator starts to flash.
4. When the red indicator stops to flash, the calibration is finished.
5. Power off and then power on the device again. The cruiser is ready to use.
EN
• Do not clean this device when in the process of charging!
• Clean this device with soft, slightly damp cloth. Do not use any abrasives or chemical
agents to clean this product.
• Do not store the vehicle if its battery level is very low or discharged. Charge the
battery before storage to prevent battery over-discharge due to a long time non-use.
• Charge the device's battery every two months if the vehicle is left unused to maintain
the longevity of the battery.
18
Owner's manual
Specifications of battery
CALIBRATION OF THE DEVICE
CLEANING
STORAGE
Werbung
Inhaltsverzeichnis
