auna Amp 3 USB Bedienungsanleitung Seite 13

1 Power On/Off and LED Indicator
Main power switch, the indicator lights when the amplifier is turned on.
2 USB 2.0 Input Interface with LED Indicator
Press  to play the last song backward, press  to play the next song
forward, and press 
song is ceased from playing, it will be memorized to resume
once the amplifier is reactivated and/or the USB input is
selected again
.
3 AUX input
Line Input. AUX/ CD IN -Lets you easily connect the computerized MP3
Device ( player) sources, such as PC( CD ROM) , laptop, walkman, iPod,
and cell phone.
4 1/4" headphone jack
5 MIC Volume Control
Lets you adjust the volume of connected MIC to the proper setting.
6 BALANCE Control
Lets you adjust the sound balance between the left and right of
amplifier outputs.
7 BASS and TREBLE Control
Allows you to boost or attenuate bass and treble for the desired sound.
8 AUX 1/AUX 2/AUX3/ USB Input Selector
Lets you select the desired input music source. When it is switched to
AUXl, AUX2, or CD input while the USB is still on playing, the playing
signal of USB continues, just it is not sent to the amplifier's output.
9 MASTER Volume Control
Lets you control the overall volume level. It doesn't affect the volume of
MIC.
10 Switchable MIC PAGER and MIXING Modes
Set to PAGER, the signal from AUX l/AUX 2/CD will be attenuated BY
-12dB and the signal from MIC will override to page (Auto Talkover), it
is good tor paging system. Set to MIXING, the signals from AUX l/AUX
2/CD and MIG will be existed at the same time, it acts like playing at
KARAOKE event.
11 MIC input jack (1/4")
Lets you connect a microphone with a 3,5-mm plug.
12 AUX1/AUX2/AUX RCA inputs
A12)AUX l/AUX 2/AUX RCA Inputs Lets you connect most high level
audio sources such as CD player, tape deck, tuner, camcorder, or VCR.
13 REC RCA Output
Lets you connect the amplifier to a tape deck for recording.
 to playand/or pause the song. When the
EN
13