Toshiba 46WM48 Series Bedienungsanleitung Seite 27

Q
Q
Why are there vertical stripes on the screen?
A
The Sampling clock may need adjustment. Select
PC Setting from the SET UP menu, highlight
Sampling Clock and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen?
A
The Clock phase may need adjustment. Select
PC Setting from the SET UP menu, highlight
Clock phase and adjust until the picture clears.
Q
Why is there a message permanently on the
screen?
A
Remove it by pressing CALL.
Q
Why is there no sound from my connected
sound equipment?
A
Check the Speaker option in the Sound menu is
set to Off.
Q
Why are there noises from the fan?
A
The cooling fans and colour wheel will change
speed during normal operations, for example,
when changing channels, this is not a malfunction.
Q
Why are there noises from the fan when the
channel is in blue screen mode?
A
If the signal is lost and the channel being watched
goes into blue screen mode, the cooling fans and
colour wheel still operate. This is not a malfunction.
Cleaning the screen and cabinet...
Turn off the power, clean the screen and cabinet with a soft, dry cloth. We recommend that you do not use any proprietary polishes or
solvents on the screen or cabinet as this may cause damage.
Disposal...
The lamp in this television contains mercury, when the lamp unit and the television reaches the end of its useful life please dispose of it
in accordance with Local Government Regulations or at a recycling centre.
uestions
and
A
nswers
Q
Why are there problems with teletext?
A
Good performance of text depends on a good
strong broadcast signal. This normally requires a
roof or loft aerial. If the Text is unreadable or garbled,
check the aerial. Go to the main index page of the teletext
service and look for the User Guide. This will explain the
basic operation of teletext in some detail. If further
information is needed on how to use text see the teletext
section.
Q
Why are there no teletext sub-pages?
A
There are none broadcast or they have not yet
loaded. Press the
(See teletext section).
Q
Why are the colours wrong when an NTSC
source is played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
EXT3
Store
Set the Colour to Auto. and exit.
1
Go to the PICTURE menu and adjust the tint.
2
26
continued
( ) button to access.
X B
Manual setting
Colour system : Auto.
A V C R
MENU Back EXIT Watch TV