Network/Bluetooth; Firmware Update - Pioneer VSX-S520D Bedienungsanleitung

> Before Start > Part Names

Network/Bluetooth

1
TV's remote controller
54
> Install > Initial Setup
2
> Playback
Make settings related to network connections and BLUETOOTH.
1. Switch the input on the TV to that assigned to the unit.
2. Press on the remote controller to display the Home screen, then select Network/
Bluetooth with the cursors on the remote controller and press ENTER.
3. Select the item with the cursor /
ENTER to confirm your selection.
0 Change the initial values for each of the settings with the cursors
0 To return to the previous screen, press
4. To exit the settings, press .
Network
0 When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting
automatically. To assign fixed IP addresses to each component, you must set "DHCP" to
"Disable" and assign an address to this unit in "IP Address" as well as set information
related to your LAN, such as Subnet Mask and Gateway.
Wi-Fi Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off (Wired) (Default Value)": Wired LAN connection
Wi-Fi Setup You can configure wireless LAN settings by pressing ENTER
when "Start" is displayed.
0 Refer to "3. Network Connection" (
details.
Wi-Fi Status The information of the connected access point will be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access point.
"Status": Status of the connected access point.
Advanced Setup | Firmware Update | Others
/ / buttons of the remote controller and press
/ .
.
P16) in Initial Setup for
E
N