Electrolux IK2755BL Benutzerinformation Seite 14

14 www.electrolux.com
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
The compressor does not
start immediately after
pressing the FastCool, or
after changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the re-
frigerator.
Water flows on the floor.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze is switch-
ed on.
The FastCool is switched
on.
The door is not closed
correctly or the gasket is
deformed/dirty.
The water drainage plug
is not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Solution
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
Refer to "FastCool function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.