Troubleshooting - auna MVD-480 Bedienungsanleitung

Device setup
Touch the system symbol on the screen to access the SETUP MENU where you can adjust many settings.
No power
• Check and make sure the connecting wireless are connected correctly
• Check whether the fuse is blown. Replace with the proper value fuse if necessay
No sound
• Check and make sure the speaker wires are connected correct!
No picture
• Check whether the video wire is connected to the video device.
Unit hang-up
• Press the RESET button to reset the unit to its default state.
• No function when pressing the buttons or TFT screen
• Press the RESET button to reset the unit to its default state.
Poor effect or unable to receive radio / TV
• Check whether the radio / TV antenna is inserted or properly connected.
• Antenna may not be the proper length. Make sure the antenna is fully extended.
• Antenna mav be poorly grounded. Check and make sure the antenna is properly mounted.
Stereo cannot be received under radio mode
• Tune the radio frequency accurately.
• The broadcast into sianal is too weak set the mode to MONO.
Disc inserted but cannot play
• Check whether the di sc inserted upsi de down.
• Check whether the di sc is dirty or badly cracked.
• Lens is dirtv. Clean lens bv usina the lens cl ean disc.
• Picture without colour or no sound under disc / TV mode
• Improper setting of colour system. Set again to PAL, SECAM or „NTSC
• The disc is dirty or damaged. Wioe the disc with a drv soft cloth or replace a new disc.
• Abnormal moving, skipping or sound during playback
• The disc is dirt or damaged
• Wipe the disc with a dry soft cloth or re lace a new disc.
•
Remote handset does not work
• Replace new battery of the remote handset.
• Point the remote handset directly at the remote sensor of the main unit.
• Clean the surface of the remote sensor.

Troubleshooting

25