Self-Diagnosis Function; Specifications - Sony Trinitron CPD-G220 Bedienungsanleitung

Self-diagnosis function

This monitor is equipped with a self-diagnosis function. If there is
a problem with your monitor or computer, the screen will go
blank and the 1 (power) indicator will either light up green or
flash orange. If the 1 (power) indicator is lit in orange, the
computer is in power saving mode. Try pressing any key on the
keyboard.
INPUT
1 2
If the 1 (power) indicator is green
1
Disconnect the video input cable or turn off the
connected computer.
2
Press the 1 (power) button twice to turn the monitor
off and then on.
3
Move the joystick , for 2 seconds.
If the monitor information and all four color bars appear (white,
red, green, blue), the monitor is working properly. Reconnect the
video input cable and check the condition of your computer.
If the color bars do not appear, there is a potential monitor failure.
Inform your authorized Sony dealer of the monitor's condition.
If the 1 (power) indicator is flashing orange
Press the 1 (power) button twice to turn the monitor off
and then on.
If the 1 (power) indicator lights up green, the monitor is working
properly.
If the 1 (power) indicator is still flashing, there is a potential
monitor failure. Count the number of seconds between orange
flashes of the 1 (power) indicator and inform your authorized
Sony dealer of the monitor's condition. Be sure to note the model
name and serial number of your monitor. Also note the make and
model of your computer and video board.
16
MENU
1 (power) indicator

Specifications

CRT 0.24 mm aperture grille pitch (center)
17 inches measured diagonally
90-degree deflection
FD Trinitron
Approx. 327 × 243 mm (w/h)
Viewable image size
(13 × 9
Viewing image Approx. 406 mm (16.0 inches)
Resolution
Maximum Horizontal: 1600 dots
Vertical: 1200 lines
Recommended Horizontal: 1024 dots
Vertical: 768 lines
Approx. 312 × 234 mm (w/h)
Standard image area
(12
Deflection frequency* Horizontal: 30 to 96 kHz
Vertical: 48 to 170 Hz
AC input voltage/current 100 to 240 V, 50-60 Hz, Max. 1.7 A
Power consumption Approx. 115 W
(without USB operation)
Approx. 402 × 418 × 421 mm (w/h/d)
Dimensions
(15
Mass Approx. 19 kg (41.9 lb)
Plug and Play DDC2B/DDC2Bi
GTF**
USB Hub Ver 1.1 1up-stream/4 down-stream
Supplied accessories See page 6
* Recommended horizontal and vertical timing condition
• Horizontal sync width should be more than 1.0 µsec.
• Horizontal blanking width should be more than 3.0 µsec.
• Vertical blanking width should be more than 500 µsec.
** If the input signal is Generalized Timing Formula (GTF)
compliant, the GTF feature of the monitor will automatically
provide an optimal image for the screen.
Design and specifications are subject to change without notice.
5
/ inches)
8
3 × 9 1
/ / inches)
8 4
7 × 16 1 × 16 5
/ / / inches)
8 2 8