Removing Weighed Items; Setting The Timer; Temperature Display; Switching The Scale Off - Bifinett KH 1156 Bedienungsanleitung

Removing Weighed Items

Press the Z/T-Button once
gramme again
Remove the desired amount of material.
The weight value of the removed material appears
in the display as a negative value.
You can repeat this procedure several times.

Setting the Timer

The Timer enables you to set the clock for a specific
period of time, at the end of which a signal tone
sounds. The preset time runs as in a countdown.
Press once on the Clock-Button
The bell symbol appears in the display
top left, next to the clock.
Enter the desired time period with the Z/T
resp. the KG/LB-button
You can set the time in 10 second steps. If you hold
the Z/T w resp. the KG/LB-button
nuously, the figures run through faster.
Press the Clock-Button
down.
You can stop the timer.
Press once on the Clock-Button
Timer.
You can reset the timer.
Press twice on the Clock-Button
Timer.
When the configured time has elapsed, a signal
tone sounds for 60 seconds.
This signal tone can be switched off by pressing the
On/Off-Button q .
w
. The scale shows 0
e
.
t at the
w
r .
r down conti-
e , to start the count-
e , to stop the
e
, to reset the

Temperature Display

When the scale is switched on, the display
shows the temperature in °C at the top right.

Switching the scale off

If you do not weigh anything for ca. 90 seconds,
the automatic power off switches the scale off.
To switch the scale off manually, press the
On/Off-Button

Troubleshooting

t
If the display
burdened. Remove material from the scale. Ne-
ver place more than 11 lb on the scale.
If the display shows „Err" for a short time and
the scale cannot be switched on, the scale is
overburdened. Remove material from the scale
and switch the scale on again. Place less than
11 lb on the scale.
If your scale does not function as expected, re-
place the batteries. Should this not correct the
malfunctioning, please contact the manufacturer.
If the display shows „LO", the batteries are de-
pleted. Replace the batteries.

Cleaning

Attention!
Ensure that liquids cannot enter the scale. Permea-
ting liquids can damage the scale.
Wipe the scale with a soft cloth moistened with mild
soap suds. Do not use abrasive or solvent cleaners.
The bowl can be cleaned in the dishwasher. The
bowl is suitable for use in dishwashers.
- 16 -
q
.
shows „Err", the scale is over-
t