Settings In Cps Mode - Aspire Puxos Bedienungsanleitung

Using the Device

Settings in CPS Mode

In CPS (Customizable Power Settings), you can finely calibrate the power curve by
pressing the "+" and "-" buttons at the same time. You can adjust the wattage with "+" and
"-", use the Fire button to select between 1 and 10 seconds. Press the two setting buttons
again to exit the submenu.
Change between °C and °F
In order to change the unit of temperature from Fahrenheit (F) to Celsius (C), increase the
temperature value to the maximum or minimum level. If you change the set value even
further above or below this range, the display will automatically switch to the other unit.
Adjust brightness/screen display
Press the setting buttons simultaneously to rotate the screen or adjust the brightness. Use
the Up and Down button to select „Brightness" and „Flip Screen", and press the Fire button
to confirm the selection. Use the Up and Down button to adjust the brightness and press
the fire button to confirm.
51