Adaptec RAID-1 Handbuch Seite 9

Step 4 Create the Driver Disk
Insert the Adaptec RAID Installation CD and turn on the computer to
a
boot from the CD.
Follow the on-screen instructions to display the CD's menu.
b
Click Create Driver Disk, then select your operating system. If you
c
selected Linux, you may also need to select an architecture (depending
on the type of Linux you selected).
Select your floppy disk drive letter, then select the format you want.
d
You need a full format only if your floppy disk is unformatted.
Insert the floppy disk, then click OK. The computer creates the driver
e
disk.
Remove and label the driver disk.
f
Continue with the installation of the operating system and controller
g
driver, as described in Step 5 below. If your operating system is not
listed in Step 5, refer to the Adaptec RAID Controller Users Guide on
the RAID Installation CD.
Step 5 Install the Controller Driver with
the Operating System
Windows 2003/XP
Insert your Windows CD, then restart the computer.
a
Follow the on-screen instructions to begin the Windows installation.
b
When prompted to install a third-party driver, press F6
c
Note: When F6 is active, a prompt appears at the bottom of the screen
for only 5 seconds. If you miss your chance to press F6, restart your
computer.
Insert the driver disk, then wait until prompted to install the driver.
d
Press S to specify that the driver is on the floppy disk, then press
Enter. The computer reads the disk.
When the driver is found, press Enter. Follow the on-screen
e
instructions to complete the installation.
5
.