Adaptec RAID-1 Handbuch Seite 5

Introduction
This Quick Start Guide describes how to install your Adaptec RAID
controller, create a bootable RAID 1 or RAID 5 array, and then install
your Microsoft® Windows® 2003/2008/XP/Vista™ or Red Hat Linux®
operating system and controller driver on that array. For other
installation options, refer to the Adaptec RAID Controllers Installation and
User's Guide included on the RAID Installation CD. For controller
illustrations, refer to the last section of this document.
Note: For the latest information about the products described in this
Guide, the support for operating systems listed, and to download drivers,
visit www.adaptec.com
Kit Contents
Adaptec RAID controller
Embedded in the controller's BIOS are these utilities:
Array Configuration Utility (ACU): Used to create, configure
●
and manage arrays
SerialSelect: Used to modify your controller and disk drive settings
●
Disk Utilities: Used to format and verify disk drives
●
Adaptec RAID Installation CD
Drivers for the Adaptec RAID controller
●
Product documentation for the Adaptec RAID controller
●
Adaptec Storage Manager
Adaptec Storage Manager: User-friendly application that you can
●
use to create and manage arrays.
Adaptec RAID Controller Configuration (ARCCONF) Utility:
●
Used to perform basic array and configuration management
functions
User Guides for Adaptec Storage Manager and ARCCONF Utility
●
Cables (type and quantity vary, depending on controller; cables are
included only with Adaptec Kit product, not Adaptec Single product)
Low-profile bracket (depending on controller)
Quick Start Guide (this document)
.
Installation CD
TM
1