Adaptec RAID-1 Handbuch Seite 7

Step 2 Create a RAID Array
RAID 1 and RAID 5 arrays are used here as an example. Create a RAID 1
if your controller does not support RAID 5. You can create a different
level array in a similar manner.
Turn on the computer, then when prompted press Ctrl+A to enter the
a
BIOS-based configuration utility. The Menu Options screen displays.
Note: If you have more than one of the same type of controller
installed, select your controller, then press Enter.
Select Array Configuration Utility, then press Enter. The ACU Menu
b
displays.
Select Initialize Drives, then press Enter.
c
Select at least three disk drives for a RAID 5 array or two disks for a
d
RAID 1. Press Insert for each selected disk drive, then press Enter.
Press Y, then press Enter. The selected drives are initialized, then the
e
ACU Menu displays.
Warning: Initializing disk drives deletes all data stored on these
drives. Back up any data you want to keep before initializing the
disk drives.
Select Create Array, then press Enter.
f
Select the disk drives you just initialized, press Insert for each selected
g
disk drive, then press Enter.
3