Windows 2008/Vista; Red Hat Linux - Adaptec RAID-1 Handbuch

Windows 2008/Vista

Insert your Windows CD, then restart the computer.
a
Follow the on-screen instructions to begin the Windows installation.
b
When prompted to specify a location for Windows, select Load
c
Driver.
Insert the driver disk, then click OK.
d
When the driver is found, press Next.
e
Click Next again to accept the default partition configuration, or refer
f
to your Windows documentation to configure partitions manually.
Follow the on-screen instructions to complete the installation.
g

Red Hat Linux

For SuSE Linux, refer to the Adaptec RAID Controllers Installation and
User's Guide on the RAID Installation CD.
Note: For the most up-to-date information on Linux support, visit
www.adaptec.com
Insert the first Red Hat installation CD.
a
Restart the computer.
b
When the Red Hat Welcome screen appears, type
c
Boot: prompt.
When prompted, insert the driver disk, then select OK.
d
Follow the prompts to set up the environment you want.
e
If you are installing other third-party devices, install them now.
f
Otherwise, select Done.
Continue with the Linux installation, according to the Red Hat
g
instructions.
Step 6 Install Adaptec Storage Manager
Before installing Adaptec Storage Manager, ensure that you are logged in
with administrator or root privileges. Also, remove any previous version
of Adaptec Storage Manager. Any customization files you created using
the previous version are saved and used in the upgrade.
To remove Adaptec Storage Manager from Linux, type the command
●
rpm --erase StorMan
.
.
6
at the
linux dd