Adaptec RAID-1 Handbuch Seite 8

On the Array Properties screen, respond as follows:
h
Array Type
Array Label
Array Size
Stripe Size
Read Caching
Write Caching
Create RAID via
[Done]
When a cache warning message is displayed, type Y.
i
Once the array is created, a message tells you that the array can now be
j
used. Press any key to return to the ACU Menu.
Note: Although you can start using the array now, performance is
reduced until the build process is complete.
Press Esc until the Exit Utility window appears.
k
Select Yes, then press Enter. The computer restarts.
l
Step 3 Set up the Boot Sequence
The process you use to access your computer's BIOS Setup program and
set the boot sequence varies by computer manufacturer. Refer to the
instructions provided with your specific computer. Steps may be similar to:
During startup, press the key combination (for example, <F2>, <F1>,
a
<DEL>) that starts the BIOS Setup program.
Go to the menu used to specify the boot sequence. Put the CD drive
b
first—this allows you to perform Step 4 on
Go to the menu used to specify the boot priority for disk drives. Put
c
the Adaptec RAID controller first in this sequence.
Save your changes, exit Setup, and restart the computer.
d
Select RAID 5 or RAID 1, then press Enter.
Type a name, then press Enter.
Press Enter, then press Enter again to use the
default granularity of GB.
Press Enter to use the default (256KB).
Press Enter to use the default (Yes).
Press Enter to use the default (Enable always).
Press Enter to use the default (Build/Verify).
Press Enter.
4
page 5.