Medion LIFE X14020 Kurzanleitung Seite 90

3.7.2. Übertragungsart
Before the station search starts, select the following options:

SCAN ENCRYPTED CHANNELS
searched for.

SELECT FAVOURITE NETWORK TYPE
use several types of reception, you can select the types below with
 Select
with

NEXT
3.7.3. Cable digital
If you have previously activated the reception type
for the network search. If it should be necessary, you can adjust the
and the
NETWORK ID
3.7.4. Satellite
If you have previously activated the reception type
antenna type.
 To set the antenna type, select one of the following antenna types:
− : Select this antenna type if you have a single receiver and a satellite antenna. Press
DIRECT
the OK button and then choose the desired satellite (you can also call up the transponder list
using the blue button). Afterwards, press the
decide whether or not the channel list should be loaded.
−
: Select this antenna type if you have multiple receivers and a single-cable system.
UNICABLE
O K
Press the button and make all the necessary settings regarding
1/2, USER BAND
using the blue button). Afterwards, press the
decide whether or not the channel list should be loaded.
−
DISEQC SWITCH
DiSEqC switch. Press the
can also call up the corresponding transponder list using the blue button). Afterwards, press
O K
the button again to start the search. After that, decide whether or not the channel list
should be loaded.
During the search, the scan progress is displayed. In addition, the number of found TV and radio
stations is displayed.
 Afterwards, press
O K
At the end of automatic program storage, a TV programme is shown.
The initial installation described here corresponds to the
INSTALLATION
: Use to select whether encrypted channels should also be

: Use
and confirm with O K
correspondingly.
SEARCH STEP
and
BAND FREQUENCY
: Select this antenna type if you have multiple satellite antennas and a
O K button and activate the desired
to continue.
option in the
INSTALLATION
to select the preferred reception method. If you

.
, you can now make settings
DIGITAL CABLE
NETWORK, FREQUENCY
, you can now make settings for the
SATELLITE
O K
button again to start the search. After that,
(here you can also call up the transponder list
O K button again to start the search. After that,
DISEQC
menu.
O K
and activate with

SATELLITE POSITION
switch (here you
1 - 4
FIRST TIME
EN
.
, the
13