Steam Ironing; Dry Ironing; Technical Specifications - Kärcher I 6006 Bedienungsanleitung

Steam ironing

All fabrics can be steam ironed. Delicate
imprints or fabrics should be ironed on the
reverse or according to the manufacturer's
specifications.
Note: For these sensitive textiles, we rec-
ommend using the KÄRCHER non-stick
ironing sole BE 6006 (Ordner no. 2.860-
142.0).
 Adjust the temperature control of the
steam iron within the notched range
(•••/MAX).
 As soon as the indicator lamp of the
heater of the iron switches off, you can
start ironing.
Note: The sole plate must be hot to pre-
vent the steam from condensing on the
sole plate and dripping onto the gar-
ment to be ironed.
 Use the top or bottom steam switch.
Steaming at intervals: Press the
–
steam switch. Steam will be emitted
while the switch is pressed.
Continuous steaming: Pull the latch
–
for the steam switch toward the rear un-
til it locks in. Steam will escape continu-
ously. To unlock, push the lock forward.
 Direct the first burst of steam at the start
of the ironing process or after ironing
breaks at a separate piece of cloth until
the steam is emitted evenly.
 You can hold the iron in an upright posi-
tion to apply steam to curtains, dresses,
etc.

Dry ironing

 Adjust the temperature of the iron ac-
cording to the garment you want to iron.
• Synthetics
•• Wool, silk
••• Cotton, linen
Note:Please observe the ironing and
washing instructions in your garment.
 As soon as the indicator lamp of the
heater of the iron switches off, you can
start ironing.
8
Troubleshooting
Often, failures have simple causes and you
can do the troubleshooting yourself using
the following overview. If you are in doubt
or if the failure is not listed here please con-
tact the authorized customer service.
Danger
Always disconnect the mains plug and al-
low the steam cleaner to cool down before
performing any maintenance work.
Repair works may only be performed by the
authorized customer service.
Steam iron "spits out" water!
 Set the thermostat to level •••.
 Rinse or decalcify the boiler of the
steam cleaner.
After breaks during ironing, water drops
will come out of the steam pressure iron.
During longer breaks from ironing, the
steam in the steam line can condense.
 Direct the first burst of steam at a sepa-
rate piece of cloth.

Technical specifications

Electrical connection
Voltage
Protective class
Performance data
Heating output
Subject to technical modifications!
EN
No steam
220-240 V
1~50/60 Hz
I
700 W