Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operations
Tool Functions
1. 2-in-1 Tool
Use brush to dust surfaces and upholstery or
crevice tool to get into narrow spaces.
2. Mattress Tool (1538M Model Only)
Use to help keep beds and mattresses clean.
3. Large Soft Dusting Tool (1538M Model Only)
Clean delicate items such as electronics or
ornaments.
4. Elbow Joint (1538M Model Only)
Use in conjunction with the soft dusting tool to
clean above cupboards and other hard to reach
areas. Adjust the elbow joint by pulling down the
spring-loaded collar lock and moving the joint to
the desired angle before releasing the collar to
lock into place.
Above Floor Cleaning
1. Twist diverter switch to horizontal position
to direct suction to the vacuum hose.
2. Push down on the handle release button
and pull the handle and extension tube out
of the body.
3. The 2-in-1 accessory, mattress tool, and large
soft dusting tool (with or without the elbow
joint) accessories can be attached to the end of
the extension tube.
4. The extension wand can be removed by
pressing the release button and pulling it off.
The 2-in-1 accessory, mattress tool, and large soft
dusting tool (with or without the elbow joint)
accessories can also be attached to
the handle end.
5. Use the dusting brush for any delicate
surfaces, ornaments or electronics, or use it with
the elbow joint to clean above cupboards, ceiling
fans or any other high up surface. The mattress
tool can be used to help keep beds clean.
6. The portable canister vacuum can be
released by pressing the button on the back
of the body and pulling away from the foot.
7. The canister vacuum can be carried around for
easy cleaning of hard to reach areas.
www.BISSELL.com
6
1.
2.
4.
3.
1.
2.
3.
4.
5.
6.
7.
Maintenance & Care
Charging the Battery
1. Remove battery housing cover by pressing
release button and pulling away.
2. Remove battery by pulling out of machine.
3. Place battery in charging base, ensuring
it is plugged into the mains.
4. Charger light will turn red during charging
and turn green when battery is full.
5. A full charge will take 2 hours.
Emptying the Dirt Container
1. Press the dirt tank release button and pull dirt
tank away from body by the handle.
2. Holding the Dirt Container over a trash bin,
press the Release Button on back. Snap the
bottom back into place.
Cleaning the Dirt Container
1. Release dirt tank as above, then twist
the top right to separate.
2. Remove filter by pulling up on the fabric
tab, then pull out the cyclone system.
3. Empty dirt container in trash bin. It may be
rinsed clean. Make sure it is completely dry
before replacing.
4. To reassemble, line cyclone system up with
dirt container using the semi circular and
square tabs then slide in. Place filter on top
with fabric tab on the upper face, place lid
last and twist left.
1.
2.
3.
4.
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
1.
2.
WARNING
Do not operate cleaner with damp or wet filters or
without filters in place.
1.
2.
3.
4.
www.BISSELL.com
LED
7
Werbung
Inhaltsverzeichnis
