Product View - Bissell POWERGLIDE 1538 Serie Bedienungsanleitung

Product View

1 Handle
1
2 Extension Wand
3 Brush On/Off
4 Power Hi/Lo
5 Dirt Tank Release Button
6 Power Button
7 Pre-Motor Filter
8 Dirt Tank
9 Battery
10 Power Brush
11 Hose
2
12 2-in-1 Accessory
13 Hose Connector
14 Diverter Switch
5
3
15 2-in-1 Tool
6
4
16 Mattress Tool (1538M Model Only)
17 Large Soft Dusting Tool (1538M Model Only)
18 Elbow Joint for Soft Dusting Tool
(1538M Model Only)
7
8
15
9
10
WARNING
Plastic film can be dangerous. To avoid Do not plug in your vacuum cleaner until
danger of suffocation, keep away from you are familiar with all instructions and
babies and children. operating procedures.
www.BISSELL.com
4
11
12
13
16 17 18
WARNING WARNING
To reduce the risk of electric shock, turn
power switch off and disconnect polarized
plug from electrical outlet before performing
maintenance or troubleshooting checks.
Assembly
Your vacuum comes in five easy-to-assemble
components:
Handle and Hose
Extension Tube
Battery
Base Unit
Foot
+
Charging Base and Accessories
1. Insert the handle into the extension wand and
click into place.
2. Slide the extension wand into the base unit.
3. Insert the hose end into the hose connector
on the back of the base unit, making sure both
tabs click into place and the notch is aligned.
4. The 2-in-1 accessory can be stored in the
clip on the side of the unit.
5. Slide body of vacuum onto foot connector
until you hear a click.
6. Push the battery into the housing until
you feel it lock into place. Replace the battery
housing cover.
Operations
14 PowerBrush Switch
1. Press the button with brush bar icon to run
the PowerBrush.
2. The PowerBrush will not run when vacuum
is locked in upright position.
3. If debris is keeping the vacuum from
operating, turn off power switch, remove
debris, and then turn power switch on to
resume vacuuming.
NOTE: Turn off the PowerBrush when
vacuuming hard surfaces, such as hard
wood or tiled floors, as well as when cleaning
smaller rugs that may be caught by the
rotating brush (see section Operate
PowerGlide® Cordless for additional details).
Power Mode Switch
1. Press the button with the +/- icon to switch
between high and low power modes.
2. High power mode is useful for cleaning high
traffic areas.
1. 2. 3.
4. 5. 6.
WARNING
Before using your vacuum, make sure that the dirt
container is in locked position and that the filter is in
place. DO NOT operate your vacuum without the filter.
1.
2.
Tip
» Before cleaning under low furniture,
check area first for objects that might
harm the unit or block the vacuum hose.
www.BISSELL.com
5