Use; Control Panel - Electrolux WS200SL Gebrauchsanweisung

USE

Before using for the first time
Before using the appliance for the first
time you should clean the interior and the
exterior,
instructions
"Cleaning and Maintenance".
Then heat the crockery warmer for at
least 2
temperature control to the maximum
position
temperature").
Make sure the kitchen is well-ventilated
when you are doing this.
The appliance's parts are protected by a
special product. For this reason, during
the first heating an odour will be
released. Both the odour and any smoke
that may form will disappear after a short
time and neither signifies that there is
anything wrong with the connection or
the appliance.

Control Panel

1. Timer indicator light
2. Temperature indicator light
following the
given in the
hours. For this,
(see section
1 2 3
4 5 6
3. Delayed Start indicator light
4. Function / ON/OFF key
5. -
cleaning
section
6.
turn the
Operating settings
'Selecting
Stand-by mode
In this mode the whole system is
disconnected and no indicator light or
display is lit.
Normal Operation
In this mode the system is generating
heat. The display shows the remaining
operating time and the set temperature
alternating each 2 seconds. The Timer
and Temperature indicator lights light-
up alternating each 2 seconds and
coordinated with the display indication.
The
illuminated continuously until the Timer
reaches zero.
To program the normal operation,
proceed as follows:
1. Press the "
times until the Timer indicator light
is flashing.
2. Press the "+" or "-" keys to set the
desired operation time in the range
0h00 – 4h00.
3. Press the "
Temperature indicator light starts to
flash.
4. Press the "+" or "-" keys to set the
desired temperature in the range
30 – 80ºC.
5. Press the "
wait 5 seconds.
6. The Warming Drawer starts to
operate with the set parameters.
ENGLISH
Operation indicator
" key once or several
" key to validate. The
" key for 3 seconds or
53
light is