Operation; Cleaning And Care - Sanitas SHK 29 Gebrauchsanweisung

3. Operation

3.1 Safety
This heating pad has a SAFETY SYSTEM. This electronic sensor technology prevents the entire
surface of the heating pad from overheating by automatically switching off in the event of a fault.
If the safety system switches off the heating pad automatically as a result of a fault, the temperature
display on the switch is no longer illuminated even when the heating pad is switched on. Please note
that, after a fault has occurred, the heating pad can no longer be used for safety reasons and must
be sent to the service address indicated.
3.2 Selecting temperature
The fastest way to heat up the heating pad is to first set the switch to the highest setting. A lower
setting can be selected later if required.
We recommend the lowest temperature setting for extended use of the heating pad.
After switching on the heating pad, the setting starts flashing briefly, while the heating pad conducts
a self-test. Then the setting remains illuminated continuously.
3.3 Temperature settings
Setting: 0 = Off
1 = Minimum heat
2 = Medium heat
3 = Maximum heat
3.4 Automatic switch-off function
This heating pad has an automatic switchoff function which stops the heat supply ap-
prox. 90 minutes after switching on the pad. The illuminated function display then starts
to flash. To operate the heating pad again, you must first set the switch to zero. After
about 5 seconds, it can be switched on again.
If the heating pad is no longer used after the timed switch-off, it should be switched off
(setting "0") or else unplugged from the mains.
3.5 Fast heating
This heating pad has a fast heating function which allows him to heat up quickly within the first
10 minutes.

4. Cleaning and Care

Before cleaning the pad, always unplug it from the mains. Smaller stains
can be removed using a cloth or moist sponge together with a little liquid
detergent for delicate fabrics if necessary. Do not use any cleaning agents
containing solvents on the appliance.
Please note that the heating pad should not be dry-cleaned, wrung out,
machine-dried, pressed or ironed.
Before washing, first remove the plug-in connection together with the switch from the heating pad.
Set the washing machine to a gentle washing cycle at 40 °C.
For ecological reasons, we recommend that the heating pad is only washed together with other textiles.
Use a washing powder or liquid for delicate fabrics and dose it according to the manufacturers
instructions.
Please note that excessive washing will wear out the heating pad.
For this reason, the heating pad should only be machine-washed a maximum of 10 times throughout
its entire life.
When drying the heating pad, do not use clothes pegs or anything similar, and never switch
the heating pad on to dry it!
Do not reconnect the switch to the heating pad until the plug-in connection and the
heating pad are completely dry.
8
90
min
STOP