Intended Use; Operation; Safety; Initial Use - Sanitas SFW 10 Gebrauchsanweisung

• Under no circumstances should you open or repair the foot warmer
(including the accessories) yourself because faultless functionality
can no longer be guaranteed thereafter. Failure to observe this will
invalidate the warranty.
• If the power connection cable of this foot warmer is damaged, it
must be disposed of. If it cannot be removed, the foot warmer must
be disposed of.
• When this foot warmer is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it
• The electronic components in the control warm up when the foot
warmer is in use. For this reason, the control must never be covered or
placed on the foot warmer when it is in use.
• It is essential to observe the information relating to the following
chapters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please
contact Customer Services.

3. Intended use

CAUTION
This foot warmer is intended only for heating human feet.
NOTE:
This foot warmer is suitable for feet up to shoe size 47 (EU)/12.5 (UK).

4. Operation

4.1 Safety

CAUTION
• The foot warmer is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the foot warmer with an automatic switch-off in the event
of a fault. If the SAFETY SYSTEM has switched off the foot warmer, the temperature settings (4) are
no longer illuminated when switched on.
• Please note that, for safety reasons, the foot warmer can no longer be operated after a fault has
occurred and must be sent to the specified service address.

4.2 Initial use

Insert the power plug into the socket.

4.3 Switching on

To switch the foot warmer on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.
13