Starting A Warm Engine - Shindaiwa T3410 Bedienungsanleitung

Engine operation
Engine warm-up

Starting a warm engine

1. Ignition switch
2. Throttle trigger
3. Throttle trigger lockout
4. Throttle latch
8. Checking that the area around you is safe, hold the position
closest to the engine firmly as shown in the illustration, pull-
ing several times on the starter grip.
9. If you hear an explosion-like sound and the engine stops im-
mediately, move the choke lever to the Open position and
continue pulling on the starter grip to start the engine.
10. If the engine starts immediately when you carry out the in-
structions in step 8, above, return the choke lever gently to
the Open position.
11. Leave the engine to warm up at idle speed for a while.
∗ When engine is hard to start, use throttle latch. (Pull throttle
trigger fully and lower throttle latch while pressing throttle trig-
ger lockout and release throttle trigger to activate throttle latch.
After engine starts, pull throttle trigger slightly to release throt-
tle latch immediately.)
IMPORTANT
If the engine fails to start after several attempts with the choke
in the closed position, the engine may be flooded with fuel.If
flooding is suspected, move the choke lever to the open posi-
tion and repeatedly pull the recoil starter to remove excess fuel
and start the engine. If the engine still fails to start, refer to the
troubleshooting section of this manual.
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
3. Never run the engine without the cutting attachment fitted.
1. Move the ignition switch to the Start position.
2. Make sure that the throttle trigger is at the idle speed posi-
tion.
3. Check that the choke lever is in the Open position.
4. If fuel tank is not empty, pull on the starter grip to start the
engine.
5. If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
22