Adjusting The Balance - Shindaiwa T3410 Bedienungsanleitung

1. Holder B
2. Safety clip
3. Output shaft

Adjusting the balance

Adjusting the shoulder harness
This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons.
Do not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
IMPORTANT
A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some per-
sons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
1. Shoulder harness
4. Bolt guard
5. L-wrench (blade not
shown for clarity)
WARNING
Before you start
5. Lock the blade in place by centering the safety clip on the
output shaft.
Never operate the product without the safety clip in
place!
IMPORTANT
The machined recess in holder B must completely surround
the safety clip, and both holders must be flat against the sur-
face of the blade.
6. Install blade holder B on the output shaft. The recess in the
holder must completely cover the safety clip and must fit
tightly against the blade.
7. Install the bolt guard and then the blade retaining bolt. Using
the socket wrench, tighten the bolt firmly in a counter-clock-
wise direction.
8. Remove the L-wrench.
1. Hook the harness hook to the hanger on the outer tube.
2. Wear the shoulder harness so that the hook stays at your
right hand side.
3. Adjust the length of the shoulder harness so that you can
hold and operate the machine comfortably.
IMPORTANT
Adjust the shoulder harness so the shoulder pad rests comfort-
ably on the off-side shoulder and the cutting path of the cutting
attachment is parallel to the ground. Make sure all hooks and
adjustment devices are secure.
Always wear a shoulder harness when operating this
product with a blade.
NOTE
Using a shoulder harness with a brush-cutter allows you to
maintain proper control of the product and reduces fatigue dur-
ing extended operation.
19
WARNING
WARNING